Details of CNC machining center safety operating procedures
Compliance with CNC machining center safety regulations, not only to ensure the personal safety of the operator, but also to ensure the normal operation of the machining center is a prerequisite for the operation of CNC machining centers, please strictly refer to the following operating procedures to ensure mechanical accuracy and service life.
1. Check the working environment
Confirm that the external environment of the CNC machining center is normal: (1) whether the emergency stop is pressed down state; (2) whether the power cord is connected to the normal without damage; (3) whether the lubricant is sufficient.
2. Power on
First CNC machining center peripheral equipment on (such as air compressor) and then from the main power supply to the machine tool once on the power.
3. After power-up
After power on (1) release the emergency stop and then use the handwheel to slowly move the CNC machining center to confirm that the machine moves normally; (2) speed rotation spindle to ensure that the spindle rotation is normal; (3) the implementation of the tool change action to ensure that the tool change is normal; (4) the implementation of the four-axis tightening and relaxation to ensure that the clamping relaxation is normal; (5) the implementation of the machining of the night action to ensure that the processing of the liquid is normal.
4. Execute simple copying program to warm up the machine.
5. Workpiece clamping
In the clamping should be cleaned up before cleaning the worktable or fixture, on the piece is to pay attention to not bumping the table, clamping good to confirm that the clamping is stable.
6. Installation of tools
(1) clean the tool so that no oil impurities on the tool; (2) clean the shank so that no oil impurities on the shank, especially the collet and taper hole; (3) clean the spindle, the spindle taper hole cleaning, pay attention not to scratch; (4) the tool will be installed on the shank, the installation should be firm; (5) will be mounted on the shank of the tool on the spindle, with a meter to measure the runout whether to comply with the use of the requirements; (6) will be the tool once the tool to the tool changer into the tool magazine.
7. Import processing program for processing
If it is the first time to use the program for a simulation to ensure that the program is correct.
8.* Change workpiece
*When changing the workpiece, clean the table surface and the contact surface of the workpiece.
9.Cleaning the machine after work
Clean up the processing waste, clean the bed, spindle, tool magazine, tool shank.
10. Machine tool back to zero pressure emergency stop, power off.
11. Turn off the CNC machining center peripheral equipment power supply, clean up the cnc machining center surrounding health